25
•
Click on
Cut Now
and a confirmation window opens where you have one more chance to note the
Force
and
Speed
at which the material will be cut. Answer
Yes
to proceed,
No
to cancel:
•
After selecting
Yes
, a
Save PLT File
window opens because earlier you had changed the connection type
to
U_Disk
. Browse to locate the USB flash drive you plan to use and name your PLT file:
•
After saving the file, you can close the
Vinyl Spooler
window. Insert the flash drive into the right side of the
Skycut. On the control panel, select
USB
and then
Open File
:
Note where design
will cut relative to
where the blade
holder is positioned
Click on
Cut Now
This figure assumes
blade holder is positioned
in the lower right corner of
the material
Locate the USB flash
drive for saving your files
Enter a file name
Click on
Save
