64
(9) Press the
Home
icon to return to the
Main Screen.
The head should move so that the blade holder is
now located over the origin target and you can proceed with the cutting process.
2.06 Other Cut Setting Functions
•
There are other functions and features available in the
Send to be Cut
window that may be useful
depending on your application. Some have already been covered. Some will be covered in this section.
Others will be covered in later parts of this manual. Note the section numbers for reference:
2.06.1 Advance Mode
•
The
Advance After Plot
option in SignMaster Pro is actually controlled on the Skycut itself. The function
can be opened by going to
Set>Advance Mode
on the control panel.
to start
will cause the blade holder to return to the origin after cutting.
to end
will cause the blade holder to advance forward to the end of the cut project.
to left
will cause the blade holder to move to the left of the cut project.
Use “-“ and “+” buttons to
set an advance amount
Select from these
three options
Section 3.03
Section 2.06.1
Section 2.02.2
Section 2.02.1 Option 3
Section 4.01.1
Section 2.06.3
Section 2.02.2
Section 2.06.3
Section 2.06.3
Section 2.06.4
Section 2.06.3
Section 2.06.2
