87
The shape is moved to the center:
(8) Depending on the print option selected in
Step (6),
the print button below the
Preview
will vary. Assuming
you selected
Print Direct
, you’ll see the option to
. Click on it or click on the button in the same
location and then complete any popup window options as needed.
Note that if you’ve already printed your
project, you will want to click on
Skip
instead:
(9) Place the printout onto the cutting mat
or load the printout directly if a cutting mat isn’t required. Note that in
SignMaster, a print and cut project is loaded “upside down” as shown in the following screenshot. On the
printout is a small arrow which is a reminder to load the printout so that the little arrow is facing towards you
as you are facing the Skycut:
Before applying
Center
After applying
Center
Click on
Print.
Note: the
wording on this button will
vary based on print option
selected in
Step (6)
Click on
Skip
if project
is already printed
Small arrow should
point downwards
Place printout this direction on mat or,
if no mat is used, this direction as fed
into Skycut
Feed this direction into
Skycut
