88
(10) Load the mat and/or printout so that it is straight, relative to the cutter.
The alignment doesn’t need to be
absolutely perfect but close enough that it will allow for a faster and, of course, successful detection by the
camera. Insert the blade holder and perform a test cut, as needed, adjusting the cut settings.
(11) Click on the
Spooler
and the
Cut Options
tab. If you want to send the cut settings from SignMaster, adjust
the
Force
and
Speeds
accordingly or select a
Preset
. Otherwise, if using the cut settings on the Skycut
control panel, turn these off. Click on
Done
after making any changes:
(12) Back in the
Contour Cutting Wizard
window, the
button should now read
Cut
. Click on
Cut
and a
new
Preview
window opens which indicates the design should be facing downwards:
Click on
Spooler
to open the
Vinyl Spooler
window
Make any necessary changes in this window
Uncheck these options if settings
on control panel will be used
Click on
Done
to
close this window
Printout should be facing this way
Set blade holder over lower right reg mark
Click on
Next
