ASSEMBLY INSTRUCTIONS
BRAKES
This rollator is supplied fully assembled with the exception of the handles,
backrest and basket.
To open
the rollator, hold it by the seat handle, push down and the wheels
will spread. The seat is now supported on the rear crossbar.
Fit the handles
to the vertical frame tubes.
Position the first handle to the height required, line up the hole for the bolt
and the appropriate hole in the handle and insert the bolt from the inside of
the frame.
Slide the curved washer onto the bolt and fit the locking wheel, ensuring the
hexagonal bolt head is located in the cut out of the tube to stop it from rotat
-
ing. Tighten the locking wheel and check the handle is secure. Repeat for
the other handle.
To fit the backrest
, locate the open ends of the backrest in the location
tubes at the front of the rollator above the seat.
Before using the walker, check the brakes operate and are correctly adjust-
ed.
When in motion, the brakes are operated by squeezing the loop handles,
each rear wheel being operated independently by the appropriate handle.
To apply
the parking brakes, push down on the loop handles.
To release
the parking brakes, pull up on the loop handles.
To adjust the brakes there are two adjusters on each side of the rollator, one
in front of the brake handle and the second at the other end of the cable just
above the wheel.
CONTINUED
LIGHTWEIGHT & HEAVY DUTY ROLLATORS
