Quickie
®
NITRUM
249817 Rev. A
26
IX. DEALER SERVICE AND ADJUSTMENT
K. FOOTREST HEIGHT ADJUSTMENT
WARNING
The footrest is an integral part of the frame. Chair should not be ridden without a footrest.
To adjust the height of your footrest, loosen the screws (H) on both footrest down tubes. Slide the
footrest up or down to the new desired height and tighten the two set screws. Use a MAX torque setting
of 62 in-lbs (7 Nm). (Frame damage may occur if overtightened.) It is recommended that you maintain a
minimum of 2.0 inches (5 c
m) between the lowest point on the footrest and the fl oor (I).
This will provide adequate clearance for uneven surfaces and prevent damage to your footrest.
1.
Flip-up Footrest
To adjust the angle of the Flip-up Footrest, loosen two bolts (J) and rotate the footrest angle stop
bracket. Once positioned, retighten bolts (J) to 92 in-lbs. For certain narrow widths, only one bolt
will be present.
2.
High Mount Footrest Mount
a. Loosen all four socket heads (K) on both sides of the chair.
b. Slide footrest to desired height.
c. Tighten socket to 62 in-lbs on both sides.
L. ADJUSTING REAR SEAT HEIGHT
NOTE - Adjustment to rear seat height may also require caster angle adjustment. See Section IX-P.
NOTE - If chair is confi gured with the 1B axle plate, the shorter camber tube clamps will be needed to
lower rear seat height by 1/2 inch. If confi gured with a 1A axle plate, it cannot be lowered and
needs longer camber tube clamps in order to raise seat height
a. Remove the set screws (A) on the rear side of the axle plate and the button head screw (B) on
the front.
b. To increase the Seat To Floor Height add a spacer (C) to the camber tube clamp (D).
c. To reduce the Seat To Floor Height remove the spacer (C) from the camber tube clamp (D).
d. No more than two spacers per side are to be used. Once complete, insert the camber system
(D) in the axle plate. Tighten the left allen screw fi rst to a torque of 62 in-lbs (7 Nm). Then,
tighten the right allen screw to a torque of 62 in-lbs (7 Nm). Repeat this procedure up to 6
times until both allen screws are evenly tightened.
52
52
55
53
54
54
54
53
55
0
15
15
30
30
45
TORQUE !
56
57
55
56
57
Summary of Contents for Quickie Nitrum
Page 33: ...249817 Rev A 33 NOTES...
Page 34: ...249817 Rev A 34 NOTES...
Page 35: ...249817 Rev A 35 NOTES...
