Quickie
®
NITRUM
249817 Rev. A
31
IX. DEALER SERVICE AND ADJUSTMENT
Q. REAR WHEEL SPACING
Rear wheel spacing is measured as the gap between the top of the rear wheels and the backcanes, and is
shown as dimension (X ) Factory settings will be as narrow as possible depending on the options chosen.
NOTE– When setting the rear wheel spacing only make adjustments to one side of the chair at a
time. Loosening both sides will undo the toe setting.
To adjust the rear wheel spacing, the camber inserts (A) telescope in and out of the camber tube (B) with
hard stops at the outer limit of travel. On the left side of the chair, loosen screws (C) (the ones closest to
the camber tube). Slide the camber insert in or out to establish the required wheel spacing. Tighten screw
to 62 in-lbs. (7Nm). Repeat on the right side of the chair, matching the wheel spacing set on the left side.
R. CHECK-OUT
After the wheelchair is assembled and adjusted, it should roll smoothly and easily. All accessories should also
perform smoothly. If you have any problems, follow these procedures:
1.
Review the set-up and check-out sections and operating guide to make sure chair was properly
prepared.
2.
Review the troubleshooting chart at the beginning of this section.
3.
If your problem persists, contact your authorized dealer. If you still have a problem after contacting
your authorized dealer, contact Sunrise Medical customer service. See the Introduction Page for
details on how to contact your authorized dealer or Sunrise Medical customer service.
73
C
A
B
73
74
EQUAL
X
74
Summary of Contents for Quickie Nitrum
Page 33: ...249817 Rev A 33 NOTES...
Page 34: ...249817 Rev A 34 NOTES...
Page 35: ...249817 Rev A 35 NOTES...
