Sunrise Medical Quickie P-222, User Instruction Manual & Warranty

930466 Rev. A

I X .   S e t - U p ,   A d j u s t m e n t   &   U s e

35

MANUAL WHEELCHAIR CONVERSION KIT

A. JOYSTICK

Removal

a. Disconnect the joystick by pulling back on the

retaining collar (A).

b. Remove joystick power cable from armrest.
c. Remove joystick assembly.

B. POWER DRIVE UNIT

Detachment

a. Release both quick-connect levers (B) until 

completely disengaged.

b. Lift seat and main frame off of power unit.
c. Set power unit aside.

C. WHEEL LOCKS

Wheel locks are installed by Sunrise when requested on
the Quickie P-222.

Adjustment

The wheel locks mount on a split clamp system. Use a
torque of 100 in./lbs. (11.3Nm) when adjusting the
position of the wheel locks.

1. Loosen the screws on the side of each clamp (C)

using a 3/16" allen wrench. Do not attempt to
remove one screw at a time.

2. Slide assembly toward rear wheel until clamp

embeds into tire to prevent wheel movement
when in the locked position. 

3. Adjust angle position. Tighten screws.

I X .   S e t - U p ,   A d j u s t m e n t   &   U s e

930466 Rev. A

34

2. Back Angle Adjustment on Seat Frame

a. Remove the front securing bolt (C) on the side of

the backrest hinge plate.

b. Loosen the lower rear bolt (D)
c. Set at desired angle. There are five holes (in 4º

increments) to choose from.

d. Reinstall the front bolt and tighten both bolts

securely.

L. 12" DRIVE WHEEL

Drive Wheel Position Adjustment

a. Remove the seat and main frame and the batteries.
b. Remove the four (4) bolts (B) using a 1/2"

wrench from each quick-connect socket.

c. Move the socket forward or backwards to the

desired position.

d. Reinstall the four (4) bolts in the quick-connect

socket. Use a torque setting of 240 in.-lbs. (27
N.m) to tighten bolts.

M. DYNAMIC STABILIZER

4" Rear Wheel Adjustment

a. Remove rear batteries.
b. Remove the upper pivot bolt (C) 

on the rear wheel spring.

c. Set at desired height.
d. Tighten nut. Use a torque setting of 240 in.-lbs.

(27 N.m) to tighten nut.

e. Height adjustment may also be made by using extra

set of mounting holes on rear wheel mount bracket.

NOTE–

The lowest point of the rear wheels should be 1/4" to

1/2" (6 to 13 mm) from the ground to allow for proper

clearance (with the tires properly inflated and rider

sitting in the chair). A smaller clearance produces less

rocking motion, and a larger clearance allows easier

movement on deep carpets.

NOTE–

In addition to the user’s weight, the seat depth and

back angle adjustment will effect this choice. Choose

the position that provides the most comfortable transi-

tion onto and off of the dynamic stabilizer wheels.

B

C

B

C

A

C

D