Quickie
®
Q200
®
R General Manual
253470 Rev. B
22
Quarterly checks
Perform the quarterly check routine before driving as described below.
1.
Check all straps for fraying, ripped seams, or other indications of
excessive wear damage. Discontinue use if damage is found and contact
a Sunrise Medical authorized dealer.
2.
Check chair for any missing or loose nuts, bolts, and / or fasteners.
Contact a Sunrise Medical authorized dealer if found.
3.
Check wheelchair for any broken components, unusual wear, or other
indicators of excessive wear. Discontinue use if damage is found and
contact a Sunrise Medical Authorized dealer.
WARNING!
1.
If you are in any doubt about the performance requirements of your
wheelchair, contact your Sunrise Medical authorized dealer.
2.
After performing any maintenance or repairs on the wheelchair you
must ensure that it is functioning correctly before it is used.
3.
A complete inspection, safety check, and service should be made by a
Sunrise Medical authorized dealer at least once per year.
4.
All fasteners must be replaced like for like using the correct length,
tensile strength, and materials.
5.
When replacing self-locking nuts, or nuts/studs secured with a thread
locking solution, ensure that a suitable thread locking solution is
reapplied to the fastener.
6.
Check all Velcro
©
fastening straps for correct adhesion when pressed
together.
7.
Ensure that any contamination, such as fl uff , hair, etc. is removed from
the Velcro
©
straps. Such contamination may aff ect adhesion.
8.
Do not reuse fasteners.
8.0 MAINTENANCE AND CLEANING
End User / Caregiver
Sunrise Medic
a
l
Aut
horized
Dea
ler
Maintenance and Inspection Schedule
Da
ily*
W
eekly
Qua
r
terly*
Annua
lly
Daily Check routine as described in Section 8.1
Weekly Check routine as described in Section 8.1
Clean wheelchair upholstery ( Seating system)
Quarterly Check routine as described in Section 8.1
Complete inspection, safety check, and service should be
made by a Sunrise Medical authorized dealer
* Daily = Before each use of the wheelchair. Quarterly = Every three (3) months.
If fasteners are found to be loose a Sunrise Medical authorized dealer should tighten the fastener to the torque setting per size detailed below,
unless stated otherwise in all appropriate owner’s manuals or instruction sheets (if applicable).
•
M8 Fasteners = 13.5-14.9 Nm [120-132 in-lbs].
•
M6 Fasteners = 6.8-7.9 Nm [60-70 in-lbs].
•
M5 Fasteners = 3.1-3.6 Nm [27-32 in-lbs].
•
M4 Fasteners = 0.7-0.9 Nm [6-8 in-lbs].
To be performed by:
