•
•
The headrest height is changed by pushing the set stop and
sliding the headrest to the desired height (Fig. 5.13)
.
The headrest forward and back position, height and angle
can all be adjusted by loosening the hinge bolts (A) with a
5mm Allen key. Move the headrest to the desired position
and tighten the bolts securely
(Fig. 5.14).
• To adjust the horizontal position, loosen the screws at the
headrest upholstery , position the headrest as required and
tighten the screws securely.
DANGER!
• If a headrest is part of the options selected for the user/
chair, never drive the chair without the headrest attached.
• Never use the chair without a headrest if a person is
transported with the chair in a vehicle.
A
Fig. 5.12
Fig. 5.13
Fig. 5.14
A
A
5.5 Pre-set headrest
5
.
4
Preset seat depth, (Fig.
5
.1
2
)
CAUTION!
When a bigger seat depth is required ensure that the cables are
lengthened before the mechanical adjustment takes place.
DANGER!
We strongly recommend that you contact your Sunrise Medical
approved
authorized dealer
to adjust the seat depth, because
adjusting the seat depth will affect the center of gravity.
5
.
4
.1
Sedeo®
Ergo (Standard), (Fig.
5
.1
2
)
• Use a 5.0 mm Allen Key, (Hex Wrench).
• Loosen the 2 screws, (A), on the bo
tt
om of the outer seat
plate, but do not take the screws out as these prevent the
shift pieces f
r
om pulling out.
• The back assembly can now be shi
ft
ed backwards or forwards
to adjust the seat depth.
• Tighten the screws.
Q700 M Ergo Seat
16
247554 Rev. A
