Fig.
7.14
Fig.
7.15
7.
8
Delete custom programmed memory
positions
Refer to Fig.
7.12
to
7.15
1.
Remove the rear cover
(A)
of the backrest and connect a
Switch
with a 3
.
5mm Jack to the socket on the CxSM,
(Complex
Seating Module) (Fig.
7.12
).
2.
Press the ”Mode” button one or more times until a seat
icon
appears in the LCD control panel display (Fig.
7.13
).
3.
Move the joystick to the left or right to select a memory
seat
position (
Seated, Pressure Relief, Supine, Feet Above Heart,
Transfer, or
C-ME
®
)
(Fig.
7.14
).
A seat icon and the memory
description for
the relevant position are shown in the LCD
control panel
display (Fig.
7.13
).
4.
Press and hold the Switch connected to the CxSM (Fig.
7.15
)
and pull the joystick backwards for 6 seconds. After 3
seconds you will hear the programming beep and after 6
seconds you will hear a change in the beep sound.
5.
As soon as you hear this new sound release the Joystick and
the button.
All memory positions are now set to the factory
settings.
7.
9
Return to drive mode
Press the ”Mode” button one or more times until a standard
display image with speed indicator appears in the LCD
control panel display.
Fig.
7.12
A
Fig.
7.13
Relax
1.
Remove the rear cover of the backrest and connect a Switch
with a 3
.
5mm Jack to the socket on the CxSM (Fig.
7.12
).
2.
Press the ”Mode” button one or more times until a seat
icon
appears in the LCD control panel display (Fig.
7.13
).
3.
Move the joystick to the left or right to select a memory
seat
position (
Seating, Supine, Pressure Relief, Feet Above Heart,
Transfer, or
C-ME
®
)
(Fig.
7
.1
4
).
A seat icon and the memory
description for
the relevant position are shown in the LCD
control panel
display (Fig.
7.13
).
4.
Move and hold the joystick forwards (Fig.
7.14
). The seat
adjusts to the factory preset position. The movement can be
stopped at any time and started again when moving the
Joystick forward.
5.
Stop the seat movement where required and select with a
left or right Joystick movement the seat actuator that needs
to be changed.
6.
Move the joystick forward or backwards until the required
position is reached. Select other actuators if required and
move them where need.
7.
Move the Joystick left or right until the factory Memory
position is reached and where the new position shall be
programmed in.
8.
Press and hold the Switch connected to the CxSM (Fig.
7.15
)
and pull the joystick backwards for 3 seconds until a beep
can be heard.
9.
Release the Joystick and the button. Your new required
position is now stored and the actuators will stop always in
this new programmed end position.
7.
7
Saving a new position to memory
Q700 M Ergo Seat
25
247554 Rev. A
