108833 Rev. A
19
S - 6 3 6
X .
• Push joystick either left or right to select one of the five drive
profiles. To select the actuator modes, push the mode select
switch twice.
• The drive profiles are indicated by the mode indicators (G)
and the actuators are indicated by the four actuator lights (H).
• To exit drive or actuator mode select, simply push the
on/off/mode toggle up one or more times until the indicator
no longer flashes, or from the mode select, push the joystick
forward or reverse to begin driving.
WARNING
1. Never use the ON/OFF switch to stop your chair
except in an emergency.
This will result in an abrupt stop, and may cause you to
fall.
2. To slow or stop your chair, return the joystick to neu-
tral.
5. Joystick (E):
The joystick controls the direction and speed of your chair. Turn
the chair on and move the joystick in the direction you want to go.
• Moving the joystick from the neutral (center) position disen-
gages the motor locks, allowing the chair to move.
• The chair will move faster the more you move the joystick
away
from neutral.
NOTE–
If your speed becomes hard to manage, release the Joystick and the
chair will come to a complete stop.
• When you release the joystick it will return to neutral; the
chair will slow to a stop and the motor locks will reengage.
• We recommend that you switch the chair off if you stop for
any length of time. This will conserve battery power.
NOTE–
Once the chair stops, switching the chair off will not affect the
motor locks.
6. Joystick Boot(F):
Make sure the boot is not torn or cracked (this could allow debris,
water or moisture to enter). If the boot is torn or cracked, replace
it as soon as you can.
7. Remote Switch Jacks (optional– not shown):
Two 1/8” mono jacks are optional to provide remote switch control of the
on/off power function and the mode select function. Any of the single
switches offered by Sunrise Medical can be used to connect to either or
both of these jacks (except the single zero touch switch).
F. MOTOR LOCKS
Disconnect the motor locks when you need to manually push the
chair. (For example, in an emergency, or if batteries fail).
WARNING
1. Do not disengage motor locks unless power to the
chair is off.
2. Be aware that the chair will not have brakes in the
free-wheel position.
3. Make sure that the person pushing the chair has full
control when motor locks are disengaged.
1
1 .. R
Re
e lle
ea
asse
e M
Mo
otto
orr L
Lo
o c
ck
kss
To release pull lever (C) to the rear
on both right & left side of chair.
2
2 .. E
E n
ng
ga
ag
ge
e M
Mo
otto
o rr L
L o
oc
ck
kss
To engage push lever (C) toward the
front on both right & left side of chair.
C
Eng
age
Rel
eas
e
