930473 Rev. B
V I I I . O p e r a t i n g I n s t r u c t i o n s – E l e c t r o n i c
13
E n g l i s h
c. Make any necessary adjustments to headrest, armrests, laterals and footplates.
d. Establish “landmarks”, i.e. adjacent reference points on headrest and user’s head– for
example, headrest cover seam and top of user’s ear.
e. Display reads: “Begin Recline– Adjust Shear...”. Begin recline by pressing and holding
left arrow. (It is recommended that programmer stand on the right side of chair.) Press
and release down arrow intermittently to compensate for shearing effect, maintaining
adjacent positions of established landmarks throughout entire recline operation.
f. When maximum reclined position is reached, press “Enter”. (You may consider check-
ing the armrest height in this fully reclined position as it may require adjustment to
the angle for best fit.)
g. Display reads: “Shear Complete– hold enter to return...”. Press and hold “Enter”, as
instructed, to return backrest to upright position.
h. Press “Escape” to exit Shear Program.
VIII. OPERATING INSTRUCTIONS– ELECTRONIC
NOTE–
When the seating system is reclined or tilted, the anti-tips are locked down and no longer have
any shock absorbing capability. This important function maintains chair stability.
A. TO OPERATE THE SMART SEAT THROUGH THE REMOTE JOYSTICK
1. From the “off” position
Push the on/off mode select toggle (A) switch down once to turn chair “on”.
2. Push the on/off mode select toggle switch up twice to light index (B) to Smart Seat
functions. Push joystick (C) left or right to toggle between options:
a. Tilt (noted by lit back and seat)
Adjusts the position of the seat and back in unison.
b. Recline (noted by lit back only)
Adjusts the angle of the back
c. Left Legrest (noted by lit left footplate only)
Elevates the left legrest
d. Right Legrest (noted by lit right footplate only)
Elevates the right legrest
e. Dual Legrest (noted by lit left and right footplates)
Elevates both legrests
3. Forward and Reverse commands on joystick (C) will activate the indicated functions
in opposite directions.
B. TO OPERATE THE SMART SEAT USING A 5-SWITCH CONTROL DEVICE
1. Locate 5-Switch input on front right of QMAC - located below seat pan.
2. Plug in 5-Switch control device.
3. The five available input choices will operate each seat function. Pressing a switch
will operate an associated function in one direction. Release and press again to
reverse direction.
NOTE–
Functions can be assigned to the five input choices using the QMAC Pendant Programmer. See
section VIII: C: Configure 5 Switch Functions.
C. TO OPERATE THE SMART SEAT THROUGH SPECIALTY DRIVE CONTROLS
Please refer to your Qtronix USCM User Instruction Manual
A
B
C
Summary of Contents for Quickie Smart Seat
Page 23: ......
