39
ENGLISH
Argon
2
Rev.C
Adjustable Back Sling
The adjustable back sling can be adjusted for tension by
using several straps.
The back sling upholstery can be accessed from the
inside via an opening and can be padded to suit individual
tastes (Fig. 4.27).
Height-Adjustable Backrest
The backrest may be set to various back heights, in 2.5
cm steps. The adjustment ranges are 25- 30 cm, 30- 35
cm, 35- 40 cm and 40- 45 cm. Release the screws (1+2)
and set the backrest to the desired height. Tighten up the
screws again (see the page on torque). (Fig. 4.28).
Sideguard
Fig.4.29 - 4.30 Parts key
1. Outer armpost
2. Height Release Lever
3. Release lever
4. Armrest pad
5. Transfer bar
6. Side panel
7. Receiver
8. Clamp
9. Receiver adjustment bolts
10. Clamp bolts
Fig. 4.27
Single Post Height-Adjustable Armrests
(Fig.4.29-4.32).
1.
Installation
a. Slide the outer armpost into the receiver mounted to
the wheelchair frame.
b. The armrest will automatically lock into place.
2.
Height Adjustment
a. Rotate height release lever (2) to second stop.
b. Slide armrest pad up or down to desired height.
c. Return lever to locked position against arm post.
d. Push arm pad (4) until upper arm post locks firmly into
place.
3. Removing Armrest
a. Pull lever 3 and lift entire arm.
4. Replacing Armrest
a. Slide armrest back into receiver until arm latches in
place.
Armrest Receiver Attachment
(Fig.4.29-4.32).
Adjusting Armrest Receiver Fit
To tighten or loosen the fit of the outer armpost in the
receiver:
1. Loosen the four receiver adjustment bolts (9) on the
sides of the receiver.
2. With the armrest in the receiver (7), squeeze the
receiver to achieve the desired fit.
3. Tighten the four bolts (9). (144 in-lbs, 16.3 Nm)
Position Adjustment
1. Loosen the two clamp bolts (10) until clamp is loose.
2. Slide armrest receiver to desired position.
3. Tighten
1
3
6
2
5
9
7
4
Fig. 4.29
10
7
8
9
Fig. 4.30
9
10
9
Fig. 4.31
Fig.4.32
7
Fig. 4.28
1
2
