34
EN
GLISH
Elite
2
Mini XS Plus Rev.B
7.3 The range of your vehicle:
Please refer to the specification tables at the back of this
manual for Energy Consumption, (Maximum Range),
information.
Most manufacturers of mobility products state the range of
their vehicles either in the sales literature or within the Owner’s
Manual. The range stated sometimes differs from manufacturer
to manufacturer even though the battery size is the same.
Sunrise Medical measure the range of their vehicles in a
consistent and uniform manner, but variances still occur due to
motor efficiencies and overall product load weight.
The range figures are calculated to I.S.O. Standard 7176. Part 4:
Wheelchair Energy Consumption Theoretical Range.
This test is carried out in controlled conditions with new, fully
charged batteries, on a level test surface and a user weight of
100 kg. The range figures stated should be seen as a theoretical
maximum and could be reduced if any single, or combination, of
the following circumstances occur:
• User weight heavier than 100 kg.
• Batteries whose age and condition are less than perfect.
• The terrain is difficult e.g. very hilly, sloping, muddy ground,
gravel, grass, snow and ice.
• The vehicle climbs kerbs regularly.
• The ambient temperature is very hot or very cold.
• Incorrect tyre pressures in one or more tyres.
• Lots of start/stop driving.
• Also thick pile carpets within the home can affect range.
• Use of additional power consumption options (e.g. light,
actuators, etc.)
The battery sizes available on each Sunrise Medical product
should give sufficient range to cope with the majority of
customer’s lifestyles.
7.4 Battery warranty:
Battery warranties are subject to periods set by the
manufacturers. However, most of these warranties are subject
to a wear and tear clause, and if you genuinely wear out
your batteries in 6 months, it will not be possible to obtain a
replacement under warranty.
7.5 Battery Removal:
Replacing and servicing batteries is to be done by qualified
specialist.
In case of malfunctioning batteries, contact your local dealer.
DANGER!
Do not attempt to replace or service batteries without the
supervision of trained and qualified personnel.
1. Remove the seat (Fig 7.2 - 7.3)
2. Remove the Battery cover by lifting the small elastic strap
off the holding peg and lifting it off (Fig 7.4)
3. Pull the two halves of the plastic battery connector plugs
apart, (Fig 7.5).
4. Remove the battery retaining bar by pulling out one clip
and sliding the bar through the hole (Fig 7.6).
NOTE:
There are two holes used for this bar, so note which
position is being used and refit the bar accordingly.
5. If replacing the batteries or battery looms, pull back the
rubber terminal cover and disconnect battery terminals,
using a 11.0mm spanner (Fig 7.7). Replace the plastic
protective terminal covers when reinstalling the batteries.
6. Bend knees with battery positioned centrally in front of
you, rest your forearms on your knees for support.
7. Grab battery handle with both hands.
8. Lift vertically by straightening legs, keeping back posture
upright.
9. Move the battery to a safe place, keeping back posture
upright and bending knees when setting it down.
NOTE:
If changing the batteries for a different size
replacement, it may be necessary to adjust the height of the
battery retaining bar to suit the new batteries. It may also be
necessary to fit the sticky backed foam battery box packer
strip to prevent any sideways play. Simply cut the strip to the
desired length. If greater depth is required, stick one strip on
top of the other.
7.6 Disconnecting batteries for air transport.
The batteries are contained within the drive unit located under
the battery shroud (refer to Figs. 7.4 and 7.5).
