37
EN
GLISH
Elite
2
Mini XS Plus Rev.B
9.0 Maintenance & cleaning
The scooter’s lifespan is dependent on it being well
maintained.
For information concerning specific settings, maintenance or
repair work, please contact your authorized Sunrise dealer.
Always be sure to mention the model, year of manufacture
and identification number provided on the identification plate
of the scooter when contacting your dealer.
CAUTION!
The scooter should be serviced by your authorized Sunrise
dealer once a year or, in the case of intensive use, every six
months. For a list of approved authorised dealers in your area
please contact Sunrise Medical Service Centre.
The contact details of your local Sunrise medical service centre
can be found on the inside front cover of this booklet.
National and International Website addresses are on the back
cover.
9.1 Maintenance
WARNING!
• Loose fasteners should be re-tightened according to the
installation instructions.
Please refer (unless otherwise specified) to the general
table below for needed Torques.
Torque Setting Guide
M4
3.0 Nm
M5
5.9 Nm
M6
10 Nm
M8
25 Nm
M10
48 Nm
M12
84 Nm
Note:
it will be necessary to use a torque wrench.
• If a broken or loose component is found, discontinue use
immediately and contact your authorised Sunrise Medical
supplier for replacement.
WARNING!
• If you are in any doubt about the performance requirements
of your scooter, contact your Sunrise Medical authorised
dealer.
• After performing any maintenance or repairs on the scooter
you must make sure that it is functioning correctly before it
is used.
• All fasteners must be replaced like for like using the correct
length, tensile strength and materials.
• When replacing self-locking nuts, or nuts/studs secured
with a thread locking solution, ensure that a suitable thread
locking solution is reapplied to the fastener.
Daily checks
Perform the daily check routine before driving as described in
chapter 5.1
Weekly checks
Perform the weekly check routine before driving as described
below.
Checking Parking brake:
This test should be carried out on a level floor with at least one
metre clearance all around the scooter.
• Switch on the control system.
• Check that the battery gauge remains on, or flashes slowly,
after one second.
• Push the wig-wag or control lever slowly forwards until you
hear the parking brake operate.
• The scooter may start to move.
• Immediately release the control lever. You must be able to
hear the parking brake operate (click), within a few seconds.
• Repeat the test a further 3 times, pushing the control lever
slowly backwards, left and right.
Checking connectors & cables:
• Check all cables are not loose and secured to the scooter.
• Check the condition of all cables and connectors for damage.
Checking controller:
• Make sure that all components of the wigwag or side
throttle are securely mounted.
Checking controls:
• Switch on the scooter – Do the lights flash? This signifies
that there is a fault in the electronic system. Refer to chapter
9 for basic troubleshooting
• Operate all of the electric options, including lights and
indicators, to make sure that they work correctly.
• Drive the scooter in each of the drive profiles to make sure
the scooter performs as it did before.
