45
EN
GLISH
Elite
2
Mini XS Plus Rev.B
Elite
2
Plus
Elite
2
XS
M
An excessive voltage has been applied to the Power Module.
Check the battery connections.
Check the correct battery charger is being used and that it is functioning
properly.
M
The parking brake has a bad connection.
Check all connections between Motor, Brake and Power Module.
M
A general control system fault has been detected.
Check that all plugs and sockets are connected.
If the scooter has been driven in extreme weather, gone through a deep puddle
or has been jet washed, place it in a dry warm environment to dry out.
M
A throttle fault has been detected.
Ensure that the throttle levers are at the neutral or rest position.
M
The scooter is being prevented from driving by the control system because of
an inhibit signal.
Check that the charger plug is disconnected from the charge socket.
M
This is not used.
M
The freewheel lever/switch is activated.
Switch the scooter off; put the scooter back into “DRIVE” mode and switch the
scooter back on again.
M
The Motor has a short-circuit to a battery connection.
Contact your servicing agent.
M
There is a bad connection to the Motor.
Check all connections to the Motor and Power Module.
Check Motor brushes.
M
The battery needs charging or there is a bad connection to the battery.
Charge the batteries.
Check the connections to the batteries are tight.
Check the battery charger is switched on and working.
Batteries need changing.
Fig. 10.4
10.3 Fault Codes and Possible Causes
