B.
Key Features:
•
Allows a variety of switches to control drive input.
•
With the Pro
Spot
proportional
switches attached the ability to have
proportional switch drive
input.
C.
Compatibility:
1.
Penny and Giles R-Net - Omni is required
2.
Curtis Electronics Enable 50 - Enhanced Display is required
3.
Dynamic Controls - DX-ACC4B Switch Interface module
from wheelchair manufacturer is required for
switched drive
controls.
4.
For use with Invacare powerchair with Mark VI electronics,
Sip
-
N
-
Puff/Digital Interface module (P/N:
SNPM6) is
required from wheelchair manufacturer
Please read these instructions carefully before beginning the installation. Failure to understand and follow
installation instructions may result in injury to installer and/or end user and may void the warranty. If you have any
questions call Sunrise Medical Technical Support at 800-376-9888.
A.
Product Description:
A smart switch box allowing the user to have mechanical switches, electronic sensors, and Pro
Spot proport
ional
switches to control a powered wheelchair. The device has 6
ports that are labeled
, forward, reverse, left, right,
off and mode.
WARNING
SET-UP GUIDE
Cool Cube Owner’s Manual
GENERAL SET UP
1. Attach the Cool Cube to the Omni by the DB9 cable.
2. Attach the various switches to be used with the device.
3. Have the Dealer program the Cool Cube for the number
of switches attached.
GENERAL USE
4 Switch Driving
3
Switch Driving
1.
Activate the switch plug
ged
into the
l
eft port to turn the powerchair to the left.
2.
Activate the switch plug
ged
into the right port to turn the powerchair to the right.
3.
Activate
the switch plug
ged
into the forward port to move the powerchair forward.
4.
Tap
switch plug
ged
into the forward port to switch the mode from driving forward to driving in reverse and
then push the switch plug into the forward port to move the powerchair in reverse.
5.
With Pro
Spot switches
press one of the switch plug
s
into either left or right port while pressing the switch
plug
ged
into the forward port to move the chair in a diagonal direction
.
249056 Rev.
C
5
Cool Cube
1.
Activate the switch plugged into the forward port to send the powerchair forward.
2.
Activate the switch plugged into the reverse port to send the powerchair backwards or reverse.
3.
Activate the switch plugged into the left port to turn the powerchair left.
4.
Activate the switch plugged into the right port to turn the powerchair to the right.
5.
Activate the right or left port and forward or reverse port to move the chair in a diagonal movement.
*
NOTE: refer to the picture above for the port order. Starting to the far left, the first port is for the right
direction, followed by the left, reverse and the forward direction on the far right.
Summary of Contents for Switch-it Cool Cube
Page 1: ...249056 Rev C Switch It Cool Cube Owner s Manual...
Page 9: ...249056 Rev C 9 Cool Cube...
Page 10: ...249056 Rev C 10 Cool Cube...
Page 11: ...249056 Rev C 11 Cool Cube...