1. Attach swingaway lateral bracket(s) (Fig. 1, D) to Contoured Cradle lateral support inter-
face plate (Fig. 1, C) using bolts (Fig. 1, A) and washers (Fig. 1, B).
2. Refer to Fig. 3. Tighten bolts (Fig. 3, A) securely. Swingaway lateral bracket may be
bolted either left or right or used in unilateral or bilateral configurations.
3. Refer to Fig. 2. Remove bolts (Fig. 2, A) and discard bottom collar half of pad (Fig. 2, B).
4. Evenly clamp the horizontal ball (Fig. 2, C) between the pad collar half (Fig. 2, D) and
Contoured Cradle lateral support interface (Fig. 2, E).
5. Refer to Fig. 4. Loosen bolts (Fig. 4, A) and clamp splitball (Fig. 4, B) between the lateral
mount collar halves (Fig. 4, C) and tighten. Do not securely tighten collar halves until fit-
ting to client to allow for adjustment of ballrod.
6. Slide collar cover (Fig. 4, G) off pad collar onto curved ballrod (Fig. 4, E).
7. Loosen collar bolts (Fig. 4, D). Loosening the collar bolts just to the point where the ball
slides in is easier than taking the collar halves completely apart.
8. Clamp collar halves (Fig. 4, H) evenly on ball (Fig. 4, F). See page 15.
9. Slide collar cover (Fig. 4, G) onto collar (Fig. 4, H).
A
Fig. 1
B
C
D
Fig. 3
A
Fig. 2
A
B
D
C
Fig. 4
D
G
E
A
C
B
C
H
F
E
Whitmyer Head Supports
Contoured Cradle Lateral Support Option
MKT6100 Rev. C
18
