ENGLISH
19
Pluton Rev.2.0
Refer to Fig.13.1-13.2
Back Angle Adjustment
• At the lower back of the chair squeeze together levers
(A), this releases them from their holding position in
holes (B).
• Whilst holding the levers together, hold the chair by the
top of the back and guide the angle of the back into the
required position.
• Relocate the levers into the relevant positioning holes
(B) to secure the back in place.
• Always ensure that the back is secure and that the
levers are located fully in a hole before using the chair.
Back Height Adjustment
• Remove the back pad cushion which is held in place
by press studs.
• Loosen the two allen key bolts (A) on the plastic back
panel.
• Slide the plastic panel up or down to the desired
height.
• Tighten the two allen key bolts securely.
• Replace the back cushion pad.
A
Fig.13.1
B
A
Fig.13.2
13.0 Back Rest Adjustment
