ENGLISH
22
Pluton Rev.2.0
Thigh Pad Adjustment (Fig.16.3-16.5)
These pads enable you to sit the client in an abducted
position which can help to lower muscle tone, create a
wider sitting base and maintain the hips in a good
position.
Inner Thigh Pad Fitting & Adjustment
• To fit the inner thigh pads, Screws A complete with
Washers B should be inserted through the carrier plate
and into the dedicated holes on the underside of the
Seating Unit.
• Tighten each screw using the 4mm allen Key provided.
• Once held on (but not fully locked off) you can continue
to set the other adjustment.
Abducting the legs
• With Screws A still loose, rotate the inner thigh pad to
the desired position.
• Once attained, lock off screws using the 4mm Allen
Key provided.
Flip Down the Inner Thigh Pad (To facilitate Transfers)
• Press and Hold Button C, whilst flipping down the inner
thigh pad.
• To reengage the inner thigh pad, simply rotate back up
and into place until it latches securely.
Outer Thigh Pad Fitting & Adjustment
• To fit the outer thigh pads, Screws A complete with
Washers B should be inserted through metal adductor
bracket into the dedicated holes on the plastic carrier
plate.
• Tighten each screw using the 4mm Allen Key provided.
• Once held on (but not fully locked off) you can continue
to set the other adjustment.
Adducting the Legs / Setting Channel Width
• With Screws A still loose, slide the outer thigh pad
along it fixing slot to the desired position.
• Once attained lock off screws using the 4mm Allen Key
provided.
Fig.16.3
A
B
C
Fig.16.4
A
B
Fig.16.5
