Port Setup
Choose a Port
The port selection button at the bottom center of the screen
reports the connection type (shown by the connector; RJ-45
here) and rate (100M/Full duplex here).
Press the button to change the port in use. The Ports Summary window appears.
The port in use is highlighted. Port and test data appears for each port.
To select another port, touch its icon.
Configure an RJ-45, Auto Negotiation
, Auto Negotiation
Configure a 1 GigE
Configure a 10 GigE
port.
if necessary.
Choose a port to test with
Tests can run on all three ports at the same time.
Port1:
XFP
– 10 GigE test
Port2/3: RJ-45 – 10/100/1000BASE-T test
Port2/3:
SFP
– 1000BASE-T or 100BASE-FX test
Possible Port Combinations
A
Port1: XFP
Port2: RJ-45
Port3: RJ-45
B
Port1: XFP
Port2: RJ-45
Port3: SFP
C
Port1: XFP
Port2: SFP
Port3: SFP
D
Port1: XFP
Port2: SFP
Port3: RJ-45
•
Port2/3 can't be selected as RJ-45 and SFP at the same time; only one
interface at a time.
Where do you want to go next?
: Configure measurement parameters
31
Summary of Contents for XTT 5000
