www.sunrotor.com
Page 32
panel array occasionally to prevent dust and debris build-up on the solar array. This will ensure the
system is being provided with all of the available power produced by the panels.
11.5
M
ISCELLANEOUS
Debris, livestock, insects, and other creatures can cause the system to run at less than optimal speeds.
When available, check wires, cables, pipes, and hose for damage caused by any number of
environmental circumstances. A few minutes to give the system a once-over can extend the life of the
solar water pumping system.
11.6
R
EPAIRS AND
R
EPLACEMENTS
In the event that the pump needs to be repaired and/or replaced, contact the SunRotor
®
Technical
Services Team at 1(866) 246-7652 or 1(580) 303-4015. You will be provided with an RMA number.
A
TTENTION
:
D
O NOT
send any equipment back to SunRotor
®
Solar Products without an
RMA. Your equipment may be lost or mishandled without the proper identification.
Detailed instructions will be provided upon contact. If required to send the pump back for repair or
replacement, please cut the pump cable above the splice (on the controller side). Including the splice
helps to determine the cause of the pump failure.
In the case of controller failure, return only the circuit board, not the enclosure. Remove the four (4)
screws holding the aluminum backplate to the enclosure. Return only the circuit board and
backplate.
For all other parts and accessories, contact the SunRotor
®
Technical Services Team.
Summary of Contents for Solar Pump
Page 1: ...SunRotor Solar Pump Installation and Resource Manual...
Page 36: ......
