Operation Instruction
30
You may select
to enter USB charging mode and the system main interface
5. After communication, unplug the MINI USB cable.
6.9.2 MS ACTIVESYNC
1. Tap
in the setting interface to enter
USB Option
as shown below.
Select
MASS ACTIVESYNC
and tap
to save the setting.
2. Install the application
Mobile Device
in a drive of PC. Then the following icon will appear in
the drive selection.
3. Connect the MINI USB terminal of the USB cable to the MINI USB port of the GPS navigator
and the standard USB terminal to the USB Host port of PC.
4. After the PC finds new hardware, double click the Mobile Device drive in the selection area to
enter the memory of GPS navigator for data transmission.
5. After transmission, unplug the USB cable.
[Attention] For data safety back up the navigator data
[Note] If MASS STORAGE is selected while the GPS navigator is connected with PC, other
operations will be suspended.
[Attention] The following operations will stop suspend the communication of the system and PC
and unsaved data will be lost.