Sunso WTP-200 v3, User Manual

20

21

9-2. Auto Cutter Specifications

(1) Cutting Frequency   

Max. 30 cuts per minute

(2) Thickness of paper   

0.06 ~ 0.09 mm

(3) Cutter Life 

1.5 million cuttings

9-3. Interface

RS232 Serial Interface, Centronics Parallel Interface(IEEE1284), USB Interface, 
Ethernet Interface(100Mbps)

9-4. Electrical Characteristics

(1) Input Voltage 

DC 24V ± 10%

(2) Current Consumption 

Operating: Approx. 1.5 A (at ASC

∥ 

printing)

Peak : Approx. 10 A 

(at print duty 100%, For 10 seconds or less)

Stand-by :  Approx. 0.03 A

(3) Power Connector

♣

Important!

When connecting or disconnecting the power supply from the printer,  be sure that the
 following cautions are observed.
(1) Use a power supply (Limited Power Supply) of DC 24V±10% and more than 1.75A.
(2) Be careful about installing the printer in an area where there is noise.
(3) Take the appropriate measure to protect against electrostatic AC line noise, etc.

9-5. Environmental Requirements

(1) Operating
Temperature 

5°C to 40°C

Humidity                 

 10% to 90% RH (without condensation)

(2) Transport/Storage (except paper)
Temperature 

-20°C to 60°C

Humidity   

10% to 90% RH (without condensation)

9-6. Reliability

(1) MCBF   

60 million lines (based on an average printing rate of 12.5% with paper 

thickness in the range of from 65µm - 75µm)

35 million lines (based on an average printing rate of 12.5% with paper 

thickness in the range of from 76µm - 150µm)

(2) Head Life 

160Km

(3) Cutter Life      

1,500,000 cuts 

9-7. Certification

(1)FCC PART15 CLASS A
(2)CE EMCD/LVD 
    (CE-EMCD class B should use parallel shield cable complied with IEEE-1284 standards)
(3) ENERGY STAR

This equi pment is indoor use and all the communication wiring are limited to inside 
of the building”