2) Needle Position Set
The positions of each needle bar can be set.
3) Limit Set
The limit of the frame can be set.
4) Wiper Sensor Set
5) Needle Height Set
Set the height of the needle bar of the Chenille embroidery machine at the default value. The height of the needle
bar can be set in the range from Step 1 to 10.
While rotating the potentiometer by hand, the corresponding lamp is turned on at some point. When the lamp is on,
use the wrench, set the needle bar height at Step 9, and fix the potentiometer.
6) Looper Position Set
You can set the initial looper position of the Chenille embroidery machine.
While rotating the potentiometer by hand, the OP Box issues a “beep” sound at some point. Then, choose one out of
the six loopers and fix the potentiometer.
7) Tension Position Set
You can set the initial position of the Chenille embroidery machine motor.
While rotating the potentiometer by hand, the OP Box generates a “beep” sound. Set the potentiometer at the color
change out of the four tension positions (chain stitch, loop stitch, color change and trimming positions).
11--33
