17
4.5.7) Pedal switch and connecting rod
1) Attach pedal switch
①
to pedal switch bracket
②
with four bolts
③
.
2) As in the Figure, attach pedal switch bracket
②
to the lower part of table.
3) Connect one end of the connecting rod
④
with
pedal switch and the other end with pedal, and
then adjust length of the rod.
4.5.8) Sewing Machine Body
1) Place the two hinges
①
on the rear bed of the
sewing machine and tightly fasten them using the
screw
⑤
.
2) As shown in figure 4-14, put the hinge
①
into the
hinge rubber
②
on the table
③
laying the and put
down the sewing machine on the bed-support
rubber
⑥
.
3) Insert the machine body sustaining pole
④
into
table
③
completely. If the pole is not inserted
completely, that may cause accidents because the
pole cannot sustain the weight of machine body
firmly, when the body bent backwards.
4) Install the sewing machine body on the table and
fix the grounding wire
⑦
on the hinge
①
using a
screw
⑧
.
①
②
③
④
[Fig. 4-12]
[Fig. 4-13]
⑦
⑧
④
①
③
⑤
②
⑥
⑥
[Fig. 4-14]
Summary of Contents for KM-1170BLX
Page 2: ......
Page 14: ...14 Fig 4 5 Thread trimming ...