15
55
Preparation Before Use
5.1) Oil Supply
A. Remove the rubber cap
①
on the arm face and supply
oil through a funnel
②
.
B. Oil should be supplied until the scale is located between
the upper and lower limit of the oil gauge
③
.
③
①
5.2) Needle Installation
A. Turn the sewing pulley and place the needle bar
①
at the
highest position.
B. Loosen the fixing screw.
C. Make the long groove of the needle
②
headed toward
the left, and fully insert the needle into the hole as in the
figure. And fix the needle with a fixing screw.
5.3) Lower Thread Placement
A. Insert the bobbin into the bobbin case as in the figure.
B. Pass the lower thread through the slot
①
of the bobbin
case and the lower part of the tension spring
②
.
③
User’s
work
direction
Needle
direction
①
①
②
②
[Fig. 11]
[Fig. 12]
[Fig. 13]
The power switch must be turned off for needle installation.
If the pedal is accidentally pressed, it may operate the sewing machine, causing injury to user.
Caution
Looking from the back of the bobbin case, the bobbin inserted should be spun counter-clockwise.
Caution