18
5.7) Remaining Thread Adjustment After
Trimming
A. During trimming, the tension of the main thread adjuster
is not involved, while the tension of the auxiliary thread
adjusting device
①
plays a role.
B. The standard remaining thread length after trimming is
35~40mm.
C. If the tension of the auxiliary thread adjuster
①
is
adjusted stronger, the remaining thread after trimming
gets shorter. If the tension is adjusted weaker, the
remaining thread gets longer.
①
Stronger
5.8) Upper Thread Placement
A. Turn the pulley of the sewing machine to locate the
thread take-up lever
①
at the highest position and pass
the thread through the thread take-up lever. This makes
threading easier and prevents thread escape when sewing
starts.
B. Make the remaining thread as long as 35~40mm from
the needle eye.
5.9) Pressured Air Input and Air Pressure
Adjustment (KM-360J-7E(M))
A. Connect the quick joint plug
②
attached to the table to
the quick joint socket
①
through which pressured air
flows in.
B. Open the finger valve
③
to make the pressured air flow
into the machine.
①
②
③
[Fig. 18]
[Fig. 19]
[Fig. 20]
Weaker
When the finger valve is closed after operation, the remaining air is automatically released, and the
remaining pressure is marked at 0MPa (0Kgf/cm
2
).
Caution