15
Caution
▶
Always turn off the power when mounting a needle.
▶
If the operator mistakenly steps on the pedal while the power is on, the machine will start automatically
and can result in physical injuries.
▶
When using clutch motor, be aware that the motor will continue to rotate for a while even after the
power is switched off due to inertia.
▶
Start to work on the sewing machine only after the motor has come to a complete stop.
1) Inserting the needle
As in Figure 21, place the upper end of the needle closely
adhered to the upper side of the stopper hole
②
, with the
needle groove
①
facing left. Fix the needle with a fixing
screw
③
. (See Figure 21)
2) Removing bobbin
Place the needle
①
in the highest position.
And then as in Figure 22, after pressing the slide plate
stopper
⑤
, open the slide plate
④
and lift the bobbin
holder
⑦
to remove the bobbin
⑧
. (See Figure 22)
3
Adjustment of the Machine
3) Winding the lower thread
Insert the bobbin
⑧
into the hook
⑥
. As seen in Figure 23,
insert the thread through
part of the hook and pull it out
from the end of the lower thread tension adjustment plate
⑨
. And then pull the thread through the clearance
⑪
between the hook
⑥
and opener
⑩
. The adequate length of
the pulled-out lower thread on the slide plate
④
is 50 mm.
Caution
▶
Turn off the power when adjusting the lower thread tension.
▶
If the operator mistakenly steps on the pedal, the machine will start automatically and can cause physical
injuries.
▶
When using the clutch motor, be aware that the motor will continue to rotate for a while after the power is
switched off due to inertia.
▶
Start to work only after the motor has come to a complete stop.
[Figure 23]
[Figure 22]
[Figure 21]
Lower thread
③
②
①
About 50 mm
⑩
⑪
⑨
⑧
⑥
①
⑧
⑦
⑥
⑤
④
groove
Summary of Contents for KM-560
Page 34: ...34 5 Table Drawing ...