20
9) Adjusting timing of needle and hook
⑴
Fixing the height of the needle bar
※
Turn the pulley to make the needle bar be placed in its lowest position. Loosen the needle bar holding screw
①
in
Figure 37 to make sure that the needle bar carved sign
ⓐ
meets the end
ⓑ
of the frame, then tighten the screw.
[Figure 36]
ⓑ
ⓐ
The needle bar in
the lowest position
[Figure 37]
①
⑵
Adjusting the timing of hook edge and needle center crossing
First, set the stitch length at
“
0
”
. Adjust the hook gear clamp screw
①
in Figure 39 so that the hook edge fall exactly at
the center of the needle center when the needle bar is raised 2.4 mm from its lowest position as in Figure 38. When this is
done, the hook edge will be placed at about 1.5 mm above from the front of the needle thread hole.
[Figure 38]
2.4mm
1.5mm
Shaft edge
[Figure 39]
①
Summary of Contents for KM-560
Page 34: ...34 5 Table Drawing ...