22
12) Adjusting feed dog height
Turn the pulley so that the feed dog
①
is positioned at its hight to adjust the feed dog
①
. Loosen the fork clamp screw
④
of
the feed dog base as in Figure 44 and move the feed dog base up and down so that the feed dog protrudes about 1 mm from
the needle plate top. After adjustment, fasten the clamp screw firmly.
13) Adjusting the auxiliary presser foot and the upper feed presser foot
※
Both the auxiliary presser foot and the upper feed presser foot move up and down.
※
It is normal that both of them move up and down to the same height.
※
Take the following steps either to adjust the stroke of both to be the same or to make one of the two adjusted lower or
higher, depending on sewing materials.
⑴
Adjusting the strokes of both to be the same
The maximum height of the auxiliary presser foot
①
and the upper feed
②
presser foot is up to 5.5 mm.
Loosen the nut
③
.
Move the nut
③
up or down, depending on sewing materials. Move it up to make the stroke increased or down to
make it decreased.
After adjustment, check the timing adjustment explained in
④
, page 24.
[Figure 44]
①
②
About 1 mm
③
④
[Figure 45]
①
②
③
5.5mm
5.5mm
Increase
Decrease
Summary of Contents for KM-560
Page 34: ...34 5 Table Drawing ...