5
5
1-1) Machine
mobilization
Danger
1-2) Machine
Installation
Caution
1-3) Troubleshooting
Danger
In need of troubleshooting, it should be done by the trained A/S engineer of our company.
ⓐ
Ahead of cleaning and repair, be sure to shut off the power supply. And wait for about 4
minutes till the machine discharges completely.
ⓑ
Even a part or all of the machine should not be modified without any consultation with
our company.
ⓒ
In case of repair, you should change the damaged part into the standard article of our
company.
ⓓ
After repair, please put again the safety cover disjointed while repairing.
Only personnel with a full understanding of the safety rules should move the machines.
The following directions must be observed when delivering the machines.
ⓐ
At least two persons should work together.
ⓑ
In case the machine should be transported, please wipe the oil covered on the machine
to prevent accidents
Because physical damage such as the functional obstacles and breakdowns are likely to
occur according to the environment in which the machine is being installed. Therefore,
the following preconditions should be fulfilled.
ⓐ
Please keep the order from top to bottom when unpacking the package. Especially,
mind that the nail on the boxes.
ⓑ
Because machines are apt to be contaminated and corroded by dust and moisture, you
should install the climate controller and should clean the machines regularly.
ⓒ
Keep the machines out of the direct rays of the sun.
ⓓ
Keep both sides and the backside of the machines off at least 50cm from the wall to
secure enough space to repair.
ⓔ
Don
’
t run the machine near the places with the dangers of explosion. Don
’
t run the
machine near the places with the dangers of explosion, including the places where the
spraying product like aerosol are used in large quantities or oxygen are dealt with,
unless the exact actions concerning the operation are guaranteed to avoid the
explosion.
ⓕ
Because of the peculiarity of the machine, any illuminators are not equipped. So,
users should install the lighting apparatus around the working area.
[Note] The details about the installment of the machine are described in
No. 2 Installations.
Summary of Contents for KM-560
Page 34: ...34 5 Table Drawing ...