5
1-1) Machine
mobilization
Danger
1-2) Machine
Installation
Caution
1-3) Troubleshooting
Danger
In need of troubleshooting, it should be done by the trained A/S engineer of our
company.
ⓐ
Ahead of cleaning and repair, be sure to shut off the power supply. And wait for about 4
minutes till the machine discharges completely.
ⓑ
Even a part or all of the machine should not be modified without any consultation with
our company
ⓒ
In case of repair, you should change the damaged part into the standard article of our
company
ⓓ
After repair, please put again the safety cover disjointed while repairing
Only personnel with a full understanding of the safety rules should move the
machines. The following directions must be observed when delivering the machines.
ⓐ
At least 2 persons should work together.
ⓑ
In case the machine should be transported, please wipe the oil covered on the machine
to prevent the accident
Because the physical damage such as the functional obstacles and breakdowns are
likely to occur in compliance with the condition of installing the machine,
The following preconditions should be fulfilled.
ⓐ
Please keep the order from top to bottom when unpacking the package. Especially,
mind that the nail on the boxes.
ⓑ
Because machines are apt to be contaminated and corroded by dust and moisture, you
should install the climate controller and should clean the machines regularly.
ⓒ
Keep the machines out of the direct rays of the sun.
ⓓ
Keep both sides and the backside of the machines off at least 50cm from the wall to
secure enough space to repair.
ⓔ
Danger of Explosion
Don
’
t run the machine near the places with the dangers of explosion.
Don
’
t run the machine near the places with the dangers of explosion, including the
places where the spraying product like aerosol are used in large quantities or oxygen
are dealt with, unless the exact actions concerning the operation are guaranteed to
avoid the explosion.
ⓕ
Because of the peculiarity of the machine, any illuminators are not equipped. So,
users should install the lighting apparatus around the working area.
[Note] The details about the installment of the machine are described in No. 2
Installations.
