Aug 04
- 3 -
Form 44080000
WARNINGS
Please note the following very important safety precautions:
Children and adults should be alerted to the hazards of high surface temperatures of the
main burner and reflector and should stay away from these areas.
Children should be carefully supervised when near the heater. This heater is not a toy and
children should not be allowed to push, climb on, or swing on the heater. This could cause
serious injury, property damage, or death.
Clothing or other flammable materials should not be hung from the heater or placed near
the heater while in operation.
Installation and repair of the heater should only be carried out by a qualified service
person.
Any part or component removed for cleaning or maintenance must be properly re-installed
before using the heater.
The installation of this appliance must conform with local codes or, in the absence of local codes,
the installation must conform to the National Fuel Gas Code, also known as NFPA 54 and ANSI
Z223.1 latest edition.
There must be adequate clearance around all air openings into the combustion chamber,
clearances from combustible materials, and accessibility and for combustion and ventilating air
supply. Clearances from the side and top must be at least 24” combustible materials.
Always place heater on a hard and level surface.
The inlet gas supply pressure must not exceed 11" W.C. Use only hose, regulator, and tank
adapter that is supplied with the product. Replacements must be those specified by the
manufacturer.
Test all fittings and connections with a soapy solution prior to use. Never use an open flame or
open flame device.
Keep water sources such as sprinklers away from the burner and controls.
Certain items or materials when stored under the heater or too close to the heater head will be
subject to radiant heat and these items could be damaged.
Review carefully and follow all assembly instructions. If you do not understand any of these
instructions please call your selling dealer or call SunStar directly at local 704 372 3486.
Carefully inspect the rubber hose included with the unit before each use. Be sure there are no
visible cracks, damage, abrasion, or other signs of visible wear. If there is any evidence of wear it
should be replaced with a Sunstar replace hose assembly.
In the event your unit uses an approved 12 foot hose please be sure that it is placed in a manner
when it cannot be damaged or positioned in a way that someone might trip over it.
Always follow the lighting and shutdown instructions to insure safe use.
The heater should be visually inspected before each use and at least annually by a qualified
service person. Certain weather conditions such as being near the ocean, dusty areas, areas with
high humidity, areas with high wind conditions, and heavy use, may require more frequent
cleaning or maintenance. When in doubt call a qualified service person. It is imperative that the
control compartment, burner system, and circulating air passages of the heater be kept clean.
