RCH100 Installation and Operation Instructions
rev: 11/15/06
7
SECTION 9: HANGING INSTRUCTIONS FOR RCH100-9B
The RCH100-9B model is supplied with a suspension ring accessory and tip-over switch. Please see Figure 3 ”RCH100-9B
Suspension Assembly” on page 7 for the approved method for suspending the RCH100-9B. The suspended weight of the
heater is 40lb.
The RCH100-9B heater is equipped with a tip-over switch as standard, the tip-over switch is connected to the thermocouple
and will safely turn off the heater if it is tipped between 25 and 40 degrees from the vertical in any direction. To reset the
tip-over switch the heater must be returned to its vertical upright position. See Figure 4 ”Tip-over Switch Details” on page 7
for details of the tip-over switch connection.
Figure 3: RCH100-9B Suspension Assembly
Figure 4: Tip-over Switch Details
Upper Suspension Ring
Suspension Leg
(2 each)
1/4-20 Screws &
Locknuts (4 each)
#10-24 Screws &
Locknuts (4 each)
Heater Rear View
Tilt Switch
3 x 3/8 Suspension holes
Closed loop
hardware
Blue
Blue
Thermocouple #K16JA-
18 Junction Block (from
gas control arm)
Tilt Switch
Weld Nut (from
shroud asm.)
#8x3/4 Screw (from
switch asm.)
LH Shroud Asm.
Summary of Contents for RCH100
Page 3: ......
