8
SECTION 10: LIGHTING AND SHUTDOWN INSTRUCTIONS
10.1. MODELS WITH IGNITION SUFFIX "-6C"
10.1.1. Turn gas control knob to "OFF" position. Allow 5 minutes for any gas to escape before lighting.
10.1.2. Turn gas control knob to "PILOT" position. Push down on gas control knob and light the pilot with a match. (See Fig-
ure 5 ”Pilot lighting hole location” on page 8). Hold this knob down for approximately 60 seconds after lighting the
pilot.
10.1.3. When the gas control knob is released, the pilot should continue to burn. If the pilot goes out, repeat Steps 1 and 2
again. Close the pilot hole swivel door after the pilot is lit.
10.1.4. Push the knob down slightly and rotate the gas control knob from "PILOT" to "ON". The main burner will ignite.
10.1.5. If the main or pilot burners extinguish, depress and turn the gas control knob to the "OFF" position, wait 5 minutes
and repeat the above lighting procedure.
CAUTION: DO NOT OPERATE MAIN BURNER AT ANY SETTING LESS THAN FULL "ON" POSITION. SOOTING WILL OCCUR!
10.2. MODELS WITH IGNITION SUFFIX "-9A" and “-9B”
10.2.1. Turn gas control knob to "OFF" position. Allow 5 minutes for any gas to escape before lighting.
10.2.2. Turn gas control knob to "PILOT" position. Push down on gas control knob and light the pilot with a match. (See Fig-
ure 5 ”Pilot lighting hole location” on page 8.) Hold this knob down for approximately 60 seconds after lighting the
pilot.
10.2.3. When the gas control knob is released, the pilot should continue to burn. If the pilot goes out, repeat Steps 1 and 2
again. Close the pilot hole swivel door after the pilot is lit.
10.2.4. Rotate the gas control knob from "PILOT" to "ON". The main burner will ignite.
10.2.5. If the main or pilot burners extinguish, depress and turn the gas control knob to the "OFF" position, wait 5 minutes
and repeat the above lighting procedure.
10.2.6. Turn the temperature control knob to the desired setting.
CAUTION: DO NOT OPERATE MAIN BURNER AT ANY SETTING LESS THAN FULL "ON" POSITION. SOOTING WILL OCCUR!
Figure 5: Gas control knob setting position
Figure 6: Pilot lighting hole location
ON
OFF
TURN BY
HAND ONL
Y
FULL
PUSH
TO
TURN OFF
SLIGHT
PUSH
TO
FROM PILOT
POSITION
NEVER USE
TOOLS
LIGHT
PILOT
ON
OFF
ON
OFF
TURN BY
HAND ONL
Y
FULL
PUSH
TO
TURN OFF
SLIGHT
PUSH
TO
FROM PILOT
POSITION
NEVER USE
TOOLS
LIGHT
PILOT
ON
OFF
Correct
Incorrect
Suffix -6C
Control
PI
LO
T
ON
OFF
PI
LOT
ON
OFF
Suffix -9A & 9B
Control
Correct
Incorrect
Pilot Lighting Hole
Swivel Door
Summary of Contents for RCH100
Page 3: ......
