-6-
WALL MOUNT INSTALLATION
IMPORTANT:
Before installing this heater, make sure that a wall stud is located in the center of the unit. This wall stud will give better
support to the unit. See the following instructions to place the "C" angle to the wall stud:
1.
Select the elbow position as indicated in Figure 2-1.
2.
Drill two (2) 5/16" holes according to the dimensions shown on the upper corner of Figure 2-1.
3.
Drill another 5/16" hole on the wall stud for the lower mounting point.
4.
Screw in the three (3) plastic expansion anchors furnished with the unit, as shown in Figure 2-1.
5.
Screw in the furnished screws to the anchors for the upper mounting points and hang the heater on the screws as shown in Figure
2-1.
6.
Fasten the bottom of the heater to the wall, inserting the screw, with a washer under the head and into the plastic anchor.
7.
Connect the gas line.
Front
7 1/16” (179mm)
