22
A. After providing with the pedal switch of 2 pressing plates,
install it a proper position to work conveniently.
B. When you are pressing the right pedal the feed plate is
lowering down, and when you press it again, the feed
plate starts rising.
C. In the status that the feed plate is lowered you press the
left pedal, lt starts sewing, and when the sewing is
finished, the feed plate starts rising.
8) How to Operate a Pedal (
A-20 Type)
Work the Right Pedal
Work the Left Pedal
A. It provides with the pedal switch of 2 pressing plates.
Install it a proper position to work conveniently.
B. When you are pressing the right pedal, the right feed
plate is lowering down, and when you press it again, it
starts rising.
C. When you press a step on the left pedal, the left feed
plate starts lowering, and when you take off your foot, it
starts rising again.
D. In the status that the right feed plate is lowered you press
a step on the left pedal, the left feed plate starts lowering,
and when you press a second step, it starts sewing.
When the sewing is finished, the left and right feed plates
start rising automatically.
E. Please refer to Page 18 in the electrical and electronic
manual concerning how to change the parameters of the
separate pedal.
9) How to Operate a Pedal ( A-22 Type)
[ Fig. 29 ]
When the oil receiving oiler at the bottom of the table is full,
take it off to empty.
10) Disposing the Waste Oil
Oiler
[ Fig. 27 ]
Work the Right Pedal
Work the Left Pedal
[ Fig. 28 ]
Spread out some fabrics of papers on
the floor when you attach or remove
the oil receiving container.
Caution
Summary of Contents for SPS/ D-B1254 Series
Page 39: ...39 DRAWING OF TABLE 9 9 ...
