59
Linear
reverse sewing
Spline
reverse sewing
Arc
reverse sewing
Circle
reverse sewing
Partial Pattern Data Delete Function
Addition of automatic back-tack
Addition of overlap stitch
X-axis Symmetrical Data Addition
Y-axis Symmetrical Data Addition
Partial Movement of Pattern Data
Deletion of pattern data
Setting-up automatic thread trimmer
Setting-up user-defined reference point for zooming
User Output Port Setting Upon Programming
User Input Port Setting Upon Programming
Entry of User Lapse Time Upon Programming
Extended I/O board output port setting
Extended I/O board input port setting
3rd thread adjustment device setting
Section design modifying function
Condensed Sewing Stitch Adding
Create the opposite sewing data of the straight line data.
Create the opposite sewing data of curve data.
Create the opposite sewing data of arc data.
Create the opposite sewing data of circle data.
Delete by selecting one from created pattern shapes.
Automatic back tacking.
Additionally proceed sewing as many numbers of stitches as the user wants.
Add pattern data selected on the basis of X-axis.
Add pattern data selected on the basis of Y-axis.
Move part of pattern to different location among the sewing shape.
Delete sewing data on any part of pattern.
Delete stitch or pattern to automatically insert thread trimmer code.
Scaling up/down based on the reference point set on any pattern.
The signal of the output port can be turned On/Off.
The signal of the input port can be turned On/Off.
The lapse time can be set to adjust the beginning time of the next motion.
Turn on/off the output port signal of the extended I/O board.
Turn on/off the input port signal of the extended I/O board.
Turn on/off the 3rd thread adjusting device with output port signal.
The designs and the properties can be modified by setting the section.
035
036
037
038
039
040
042
043
044
046
048
055
056
057
058
059
61
62
63
64
041
045
NO.
Function
Contents
It is the function to prevent stitches from being untangled by making stitch
width condensed in sewing start part and sewing end part of pattern data.
Point Symmetrical Data Addition
Add by making symmetric pattern data on the basis of
end point of pattern data.
047
Copying Function of Pattern Data to
Specific Location
Set a fixed part of pattern shape and copy to desired
location.
050
Change/Saving Function of Maximum
Pattern Sewing Speed and
Extension/Reduction Rate
Set up maximum sewing speed and extension/reduction rate by
pattern.
051
One Stitch Movement Function
It uses when correcting the location of one stitch in the formed
sewing shape.
052
A Fixed Number of Stitch Delete Function
Delete 1-99 stitch in the pattern data shape after the start point to delete at present.
053
Change/Saving Function of Pattern Data Start Point
Change and save pattern data start point already set up when punching.
054
060
Change/Saving Function of Pattern
2nd Original Point
Change the already setup 2nd original point to new 2nd original point
and save it.
User's Presser Foot Height Setting
This function is to enable the user to adjust the presser foot height depending on
sewing fabric thickness, and the sewing data is produced accordingly.
049
Partial Pattern Data Delete Function
Delete one of the generated pattern data shapes selectively
(For example: Jump, Line, Curve, Arc, Circle).
033
034
Arc
double reverse sewing
Circle
double reverse sewing
Set the offset based on arc to create the same type of sewing data.
Set the offset based on circle to create the same type of sewing data.
Summary of Contents for SPS/E-5050 Series
Page 2: ......
