GAS SETUP – INSTALLATION OVERVIEW
PAGE 10
CAUTION:
Gas conversion kits are available from Customer care by dialing 888-934-9449.
When ordering gas conversion kits, have the model number, and the type of gas (natural or LP) ready.
Use only the gas pressure regulator supplied with this appliance. This
regulator is set for an outlet pressure of 11 inches water column.
An installer-supplied gas shut-off valve must be installed in an easily
accessible location.
All pipe sealants must be an approved type and resistant to the
actions of LP/NG Gas.
Never use pipe sealant on flare fittings.
All gas connections should be made by a qualified technician and in
accordance with local codes and ordinances.
Before connecting grill to gas source, make sure BBQ Grill control
knobs are in “OFF” position.
Verify the type of gas supply to be used, either Natural Gas or Liquid
Propane, and make sure the marking on the appliance rating label
agrees with that of the supply.
The installation of this appliance must conform with local codes or, in the
absence of local codes, with either National Fuel Gas Code, ANSI Z223.1/ NFPA
54, Natural Gas and Propane Installation Code, CSA B149.1, or Propane Storage
and Handling Code, B149.2, or the Standard for Recreational Vehicles, ANSI A
119.2/ NFPA 1192M, and CSA Z240 RV Series, Recreational Vehicle Code, as
applicable.
ATTENTION:
Always take a leak test before lighting the grill to prevent a possible fire or explosion.
Never store a spare propane
cylinder in the vicinity of this Grill, or in the vicinity of any other potential heat
source. Never attempt to attach this grill
to the self-contained LP gas system. Do not use grill until leak
testing.
