![background image](http://html1.mh-extra.com/html/sunstone/sunchsz30/sunchsz30_manual_1400495029.webp)
Q. LED Light is not functioning while interior lights are ON
A.
Likely your LED Light has malfunctioned due to the grill being overheated, or there may be a loose wire on
the internal control circuit board. You can access these components by sliding the grill out from your island
approx. 6 Inches, there are 4 screws on either side holding the front control panel to grill body, and 4 Alan
Wrench Screws on the inside facing towards front panel, you will see 4 Holes. Removing these screws will
allow the main control panel to be removed revealing the internal LED light and Circuit Board. You can then
easily unplug and replace LED light with new one or check for other loose connections.
Q. Either One or Both Interior Lights do not work but LED Light works
A.
Most often the interior Halogen Lights will burn out one at a time, if both are out at the same time, you
could have a connection issue. Check the Plug in the back bottom Left of grill, the plug consists of two sockets
on either side, check to make sure each is securely pushed in. If all the Lights do not work, then it is either
unplugged or the Transformer has malfunctioned. Each Halogen light can be replaced by unscrewing a single
screw per light located on left sides of light cover, the entire light box needs to be removed, and there are two
small black wires hard-plugged into back of light. Use a pair of plyers to remove these, replacing to new
Halogen Light box, again use a pair of plyers to push each wire into each socket of light box, Test light is
working before inserting back into hole and again tightening the small screw on left outer side.
Q. The Gas Burners flame is very Low
A.
If your grill is using a 25 Pound Portable tank and is directly connected to grill with no other appliance, you
may have a Spider Web or other clog in the gas Pipe. If your grill is connected to a Side Yard 500 Gallon Tank,
there may be an issue with the Regulator – either it is a Low-Pressure Regulator being used, or not enough gas
pressure is being allowed to the grill. If you have any T-Connections in gas line going to other outdoor
Appliances like a Fireplace or Side Burner, this can also greatly diminish gas flow.
TROUBLE SHOOTING
PAGE 25