9
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
We recommend to use pellet with size of
6 - 8mm. Density 600 - 750kg/m
3
heating
value 4.7 - 5.5 kWh/kg. Ash content – less
than 1% and moisture content up to 8%,
EN 14961-2:2011.
The optimal density of the pellets which
guarantees their quality is 605-700 kg per
cubic meter.
Pellet moisture content must not exceed
10%. Make sure you store your fuel in a
dry and well-ventilated place.
The optimal pellet ash content is ≤ 1%.
This also provides for less frequent
cleaning intervals for the burner.
The table 2 below contains the
parameters which we recommend
that you take into consideration when
choosing fuel for your „Pell ECO” burner.
4. TRANSPORTATION OF THE PELLET
BURNER
When loading, transporting and
unloading of the device appropriate
safety equipment must be used in
accordance with Directive 2006/42/SE.
Product must be in original packaging
following the instructions on the label -
to be protected from adverse weather
conditions (snow, rain and dust) from
the shocks, and other activities likely to
cause damage. In case of malfunction of
the fan or the motor drive (noise, friction)
or failure of high-tech elements such as
broken LCD screen, contact your nearest
authorized service center for repairs and
maintenance.
- Dimensions of the packaging of the
burner:
Pell 35 ECO Pell 55 ECO
Width, mm
285
300
Length, mm
625
755
Height, mm
545
545
- Dimensions of the packaging of the
auger: 260х120х1700 mm
5. DELIVERY OF THE PELLET BURNER
• Inspect the integrity of the packaging
upon delivery.
•
Check whether all components
have been delivered to you. Burner
consignment package includes
(diagram 3):
Diagram 3. Pell ECO burner consignment
elements
1) Pellet Burner Pell ECO with built-up
Control unit
2) Feeding chute mounted to the burner
3) Auger
4) Technical passport. Installation and
operation manual
