TECHNICAL PASSPORT INSTALLATION and OPERATION MANUAL
3 - EN
1.
Safety instructions
1.1. Requirements to solar collector installation place
This manual contains important information for the safe and correct installation, start-up and
trouble-free operation and maintenance of the solar collector.
The solar collector can be used to produce domestic hot water and support of space heating system
only in the manner described in this manual.
The application and any other was the area of operation is not recommended by the manufacturer
and is not responsible for the occurrence of defects or failures.
Note the collector type data on the factory rating label and the technical data provided in this
manual in order to ensure proper operation of the product.
1.1.1.
Instructions to collector installer
During installation and operation, the country-specific requirements and regulations must be
observed:
• local construction regulations on installation on building – mass of the system to comply
with the building structure.
Fixation of support must be in compliance with local regulations and requirements regarding
wind/snow load resistance (if necessary take measures to make them compliant)
• regulations and norms concerning safety installation and operation of solar collectors -
protective gloves, eyewear should be used; make sure collector is securely attached to the
building.
Use only original parts
DANGER of structure damage / injury from fall. The weight of collector/collectors must
comply with the building structure, namely the distribution of weight; strong and secure
fixation of collector support to the roof/façade of building. We recommend the securing
of the area during installation and the construction of roof barriers protecting against
downslide of snow mass. Failure to comply with these recommendations can lead to fatal
consequences.
Risk of injury, burn
upon installation and maintenance of solar collectors:
-
On contact with broken glass/vacuum tube
-
On contact with collector in function because of its high temperature.
We recommend the use of protective equipment, gloves, eyewear (goggles), clothing.
Installation and maintenance of collectors must be carried out in
the early morning hours.
When the collector is still cold you can cover it
with tarpaulin to avoid its heating by direct
sunlight.
FIRE HAZARD
through contact of accumulated waste (dry leaves, plastic bags, paper) with
the hot parts of the collectors. We recommend the regular inspection and cleaning of
collector installation sites.
