8th
vertically at the top of the UAV.
3) It is recommended to use 29cm long antenna. The best installation position is the center of the UAV tail,
prominent outside the body and vertical downward.
4)
The second optional mounting position is located below the wing and body joints, vertical down, as far
as possible away from the wing but near the machine abdomen, protruding below the abdomen level.
VIII. Software Operation
1. Start Connecting Tdd-cofdm equipment
First, enter the IP address
，
Next click Connect TDD button.
2. Restart TDD-COFDM Control Panel software
:
click Restart TDD button.
3. RF Configuration method
3. 1. TX Rate
（
Default
：
QPSK FEC 1/2
）
:
This setting determines the modulation type and in turn the rate at which the data is to be
wirelessly transferred.
The default and recommended setting for both Master and Slave
units is ‘Auto’.
When in ‘Auto’ the unit will transfer data at the highest possible rate in
consideration of the receive signal strength (RSSI).
Refer to Performance for a table breakdown of performance at selected rates. If setting a
fixed TX Rate It is recommended to retain a fade margin of at least 10 dbm for optimum
