12th
6. IP New Network Configuration method:
This setting helps you to change the IP address of devices .The default of master’s IP address is
192.168.55.1
,the default
of slaver’s IP address is
192.168.55.2
.
For example,you want to change the master’s IP address to “192.168.55”. Then do
as the following steps.
IP Set :
192.168.55.5
IP Mask Set:
255.255.255.0
IP Gateway Set:
192.168.55.1
Next Connect
IP NEW NETWORK
button.
Attention!
When you have changed the IP address ,you should correct another
device ‘s “Remote IP Addr” into the same “IP SET”, or the serial port will lose
connection.
For example , you have changed the master’s IP address to “192.168.55.5”, the you
should correct the salver’s “Remote IP Addr” to “192.168.55.5”.
7. RF New NET Configuration method:
7.1. RF Net ID:
Each network of TDD-COFDM modules must have a unique Network ID. This
Network ID must be set in each unit on the network.
7.2. RF Encrypt KEY
This is the password, or preshared key that is required by any device to connect to the wireless interface of the
TDD-COFDM. It is strongly recommended to always have a password defined, and changed from the factory default.
