3rd
11) After starting the product, the self-test indicators of ST30HPT will continuously blink for 30s and then keep
bright. Only after the video from the camera shown on the display, then you can confirm that the device work
properly now.
12) Check the surrounding environment to ensure there is no other 2.4GHz devices to cause interference.
13) If you use the Futaba remote controller, the controller should be adjusted into the French mode. Otherwise, the
video transmission performance will be serious affected
14) Adjust the Futaba controller into French mode as following steps:
15) [LINKAGE MENU]→FRQUENCY→ RTN b→ [AREA]→[FRANCE]
Or connect ST30HPT S1 serial port with trainer interface on back side of Futaba by TTL cable. And set the Futaba RF
as OFF. Through the S1 port uplink the PPM/SBUS signal.
16) Before using, please check the power of RX and TX. If the receiver power off, transmitter on board will lose
connection.
17) Adjusting RX antenna inclination can improve the signal strength and image quality.
18) The camera should be fully charged to ensure normal video output.
19) ST30HPT support video and duplex data communication. If the video stuck or stopped for more than 10s. It
means the radio signal is weakened or the radio channel is narrowed. In this case, the aircraft need to fly back
to short the distance between TX and RX. Otherwise, the TX will lose connection.
20) Please use good electromagnetic shielding accessories(HDMI Cable, HD display and so on)
Notes:
Improper operation of ST30HPT may cause personal injury or damage to properties. Please pay high attention
to operation safety.
III. List of in-box items
On board x1
Ground terminal x1
