8th
1. Make TX and RX and accessories ready.
Besides the whole equipment we supply, you also need to make sure the video source, display and power ready
before operating.
2. Connection
Make the power cable, HDMI Cable,
Ethernet cable, serial port cable and
antenna in good connection.
(Ethernet cable is used to output video
to PC, the serial port cable is for data
links)
3. Power on
After checking all the connections are in good condition, turn on the the
video source, LCD display, transmitter and receiver. The PWR indicator will
bright and the whole system starts work.
4. The status of all indicators during starting
When the device begin to normally start work, all indicators status is described as follow:
1
After power on, light 1,2,3 turn green, light 6 turns blue.
2
After few seconds, light 1,2,3,6 start flashing. And light 5 green is normally on.
3
After the starting complete. Light 1(Green), 2(Green), 3(Green), 6(blue), 4(Red) are normally on. Light
5(Green) will fast blink.
4
When data transmission goes well, WL green light will
flicker.
Remark
：
Light1, 2, 3 are indicator for signal strength.
1
Light 1 on: Signal Weak
2
Light 1,2 on: Signal Normal
3
Light 1,2,3 on: Signal Strong
