5th
4
4. Connect the antenna and monitor display with of RX
5
5. Turn on the power of RX
6
6. Modify the parameters of RX
After the successful parameters modification, the RX will research the TX signal automatically
4.2. How to adjust the TX parameters
State
：
Signal strength( indicated by the percent)
Freq
：
Receiving Center Frequency
Band
：
Frequency Bandwidth
PoE
：
RF Connector Power Supply
（
Default OFF
）
AES
：
Manual AES Encryption
（
Default OFF
）
L: Left/R: Right /U: Up/D: Down/M: Menu
4.2.1. The Keys Functions:
1
Adjust Video Source Type: HDMI, SDI and CVBS
2
Adjust the Frequency
3
Adjust the Frequency Bandwidth
4
Adjust the Gain
5
Adjust the Encryption
4.2.2. Modification Steps
1
Press Up or Down keys to choose the term you want to adjust.
2
Long Press Menu key to get Modify Mode
3
Press Up and Down keys to adjust the parameters.
4
Long press the Menu key to save the parameters
4.3. How to adjust the RX parameters
State
：
Signal strength( indicated by the percent)
Freq
：
Receiving Center Frequency
Band
：
Frequency Bandwidth
PoE
：
RF Connector Power Supply
（
Default OFF
）
AES
：
Manual AES Encryption
（
Default OFF
）
L: Left/R: Right /U: Up/D: Down/M: Menu
4.3.1. Modification Steps
1
Press Up or Down keys to choose the term you want to adjust.
2
Long Press Menu key to enter Modify Mode
3
Press Up and Down keys to adjust the parameters.
4
4. Long press the Menu key to save the parameters
Note:
When the RX turn on, the LCD will blink to identify the wireless signal. After it successfully received the signal,
the green color signal value percent will be displayed on the state. If the receiver does not receive the signal, the
value percent will be in blue color.
Remark
：
Before the system shipping out, all the parameters have been set by our engineers. So there is no need to
