OPERATION & MAINTENANCE MANUAL SWE18UF
59
9)
Fit and screw down outlet plug.
10)
Clean surrounding area of engine oil filter seat. Turn the filter cartridge anti-clockwise to
remove old seals.
11)
Clean sealed washer surface of filter seat.
12)
Wipe clean oil on the seals of new filter.
13)
Fit new filter, turn filter clockwise until the washer touch interface. Ensure not to damage
washer when fitting filter.
14)
Screw down engine oil filter. Remember not to make it too tight to prevent screw thread
distortion or filter element seals damaging.
15)
Open oil filter cover, and fill recommended oil in engine 15 minutes later, check whether the
oil level lies within the marking range or not.
16)
Fit filler cap.
17)
Start engine. Run at low revs for 5 minutes.
18)
Check whether the engine oil pressure indicator light goes out at once, if not, stop engine
and check for the reason.
19)
Stop engine, take out key from key switch.
20)
Check whether there is any leakage at outlet plug.
21)
Check oil level on dipstick
4.2.3 Gear Oil
Parts name
Qty
Interval (hours)
8 50
100
250
500
1000 2000
Travel
reduction
gearbox
Check
oil
level
—
lubricated by hydraulic oil piping
Replace
—
—
Travel
reduction
gearbox
Check
oil
level
—
△
Replace
2*0.33L
△★
△
【Note】：
The initial replacement time is 250 hours of operation, after that is 1000 hours.
